Recommended ways of interacting with GPIO on resin.io devices.
The Raspberry Pi's General Purpose I/O (GPIO) pins can be used to send and receive arbitrary data from external hardware. In the diagram shown below the GPIO pins are located in the top-right hand corner of the device:-
File System Access
You can use the file system directly to access GPIO pins using a terminal connection, scripts deployed to your Pi, or the file system interface of your programming environment.
GPIO pins are exposed via the Linux sysfs file system at
/sys/class/gpio/gpio[pin number], e.g. pin 17 would be accessible via
In order to gain access to a pin it first has to be exported - you can do this by outputting the desired pin number to
/sys/class/gpio/export. You can later 'unexport' this GPIO pin by outputting this number to
Once a pin is exported you need to set its 'direction' - in or out - via
From then on you can output raw data to
/sys/class/gpio/gpio[pin number]/value bit-by-bit - 0 is interpreted as a low signal, 1 or any other non-zero value is interpreted as a high signal.
E.g. accessing GPIO port 17 and sending some data:-
# ls /sys/class/gpio/gpio17 ls: cannot access /sys/class/gpio/gpio17: No such file or directory # echo 17 > /sys/class/gpio/export # ls /sys/class/gpio/gpio17 /sys/class/gpio/gpio17 # echo out > /sys/class/gpio/gpio17/direction # echo 1 > /sys/class/gpio/gpio17/value # echo 0 > /sys/class/gpio/gpio17/value # echo 1 > /sys/class/gpio/gpio17/value ... # echo 17 > /sys/class/gpio/unexport # ls /sys/class/gpio/gpio17 ls: cannot access /sys/class/gpio/gpio17: No such file or directory
For more details on sysfs GPIO access see the official kernel documentation.
All numbered data pins operate at 3.3v, however there are two 5v ports which output 5v DC output.
Please note that these are operating at a different voltage from the data pins - if you need to drive a 5v (or higher) device, you will need to use a level converter to step up the data pin's voltage or your device will not be able to correctly interpret high signals from the Pi.
Currently the Beaglebone devices are running a very new 4.1 kernel (which is obviously awesome), unfortunately many of the userspace libraries haven't caught up yet so they only work with the older 3.8 kernel. Luckily ruth0000 was kind enough to patch the Octalbonescript JS library and made a lovely node.js module over here: https://www.npmjs.com/package/octalbonescript_capemgr4_1 .
With this module you should be able to basic GPIO and analog-to-digital conversion stuff. To get you started we have a simple example using this module here.
If you would prefer a python implementation, then look at this github issue and get involved in making it happen.